DGSI EZ-DAQ Manuel d'utilisateur télécharger pdf (Page 18)

SOIL-DAQ™

CALIBRATION

Operator’s Manual EZ-DAQ™ version 1.4 18 of 25

CALIBRATION

1.0 Calibration of Sensors

Note: EZ-DAQ is configured for either SI or US customary units. At present, the internal

software does NOT allow the user to switch between the two units.

Press the “CONFIG” button on the Sensor

Configuration Block to enter the calibration

configuration part of the screen software.

A window will open asking for a password.

The factory default password is 1234. It is

recommended the password is not

changed to facilitate factory support.

IMPORTANT NOTE

 To configure or calibrate sensors, EZ-DAQ need not be connected to a PC

unless you want to collect data. This chapter is intended for a certified

calibration technician only.

Password:

1234

<enter>

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25

Pas de commentaire

DGSI EZ-DAQ Manuel d'utilisateur Page 18